Page 1 of 1
Posted: Thu Dec 13, 2001 9:09 am
by Jason
Has anyone interfaced a pair of M120 2 Channel 16 pin radios with a RICK?
I have heard you must have an 8 or 16 channel radio??
Any ideas??
Thanks
Jason
Posted: Thu Dec 13, 2001 10:59 am
by Monty
Hi:
According to the Sales Book, the M120, 8 ch, 16 ch GM300 is compatable with the R*I*C*K
There are a few " Internal Jumpers" and
mods required, and that information can
be found in the manuel.
MS
Posted: Thu Dec 13, 2001 1:39 pm
by vcaruso
In a basic repeater setup two M120s will work, in cross band although it will not since the pins on the M120 are not RSS Programable.
Vince
Posted: Thu Dec 13, 2001 1:46 pm
by perthcom
The only problem that I have had with M120's as a repeater is the COS/PL/DPL detect pin is an open collector output pulling to ground. I've simply added a pull-up resistor so the High on COS is detected.
Hope that helps
Posted: Fri Dec 14, 2001 3:34 pm
by Will
My RICK module WILL work, and for a lot less cash (1/5th or less) + it includes the proper radio to interface cables built in! It is plug and play!