Maxar 50 PL

duck23 · Post by **duck23** » Sat Mar 23, 2002 11:30 am

I'm looking for the programming of the diodes for the Maxar50.Can anyone help?

10-95 · Post by **10-95** » Sat Mar 23, 2002 11:44 am

Hi, i don't have the info you need , but here is a suggestion. The ht90 series handie talkies had the programmable pl like that also, check the batlabs model info page for the ht90, the maxar may use the same instructions.

Frank

Tom in D.C. · Post by **Tom in D.C.** » Sat Mar 23, 2002 1:13 pm

I have this info at home but I won't be there until Monday. There are two sets of diodes you have to cut or connect and it's sort of tricky.

I'll private mail the data to you next week.

Regards,

Tom, W2NJS
...in D.C.

P.S. Hello Frank.

EC-7 · Post by **EC-7** » Sat Mar 23, 2002 11:49 pm

If you have the DPL diode settings I could use those.

Tom in D.C. · Post by **Tom in D.C.** » Sun Mar 24, 2002 10:59 am

Duck and Mark:

I realized after posting my first answer that this info is much too long to put into an e-mail, so if you guys will send me your snail mail addresses, preferably by regular e-mail, I will photocopy the data and mail it to all of you.

Regards,

[email protected]

Tom, W2NJS
...Washington DC

duck23 · Post by **duck23** » Thu Mar 28, 2002 6:10 pm

On 2002-03-23 16:13, Tom in D.C. wrote:
I have this info at home but I won't be there until Monday. There are two sets of diodes you have to cut or connect and it's sort of tricky.

I'll private mail the data to you next week.

Regards,

Tom, W2NJS
...in D.C.

P.S. Hello Frank.

Thanks I'll send a private email.

Dwayne N3LEL