DECODE THIS MODEL #

CHEFA2001 · Post by **CHEFA2001** » Sat Apr 06, 2002 11:00 pm

Model C44CLB-7105AT

tHANKS anyone who can help

On a repeater MSF5000.

Band, etc, info wanted.

Thanks

[ This Message was edited by: CHEFA2001 on 2002-04-07 03:01 ]

Monty · Post by **Monty** » Sun Apr 07, 2002 12:49 am

On 2002-04-07 03:00, CHEFA2001 wrote:
Model C44CLB-7105AT

tHANKS anyone who can help

On a repeater MSF5000.

Band, etc, info wanted.

That is a Motorola MSF5000

Only the Chassis Numbers can tell you if
its a Low Range radio 403-433, 450-470, ect

It is also prorgrammable ( only ) by a Motorola Suitcase Porgrammer ( EEproms ) and
is a nice unit, just expensive to maintain.

Monty

Thanks

[ This Message was edited by: CHEFA2001 on 2002-04-07 03:01 ]

CHEFA2001 · Post by **CHEFA2001** » Sun Apr 07, 2002 6:34 am

Thanks Monty

Doug · Post by **Doug** » Sun Apr 07, 2002 12:31 pm

CHEFA2001
I was looking thru my MSF stuff and according to the numbers that you give it breaks down to a 40 watt 403-470 DC control analog station. If you desire a full package breakdown I can dig a little deeper in the book.
Doug
Unfortunately it doesn't tell me if its a range1 range2 or whatever only that its somewhere between 403-470

[ This Message was edited by: Doug on 2002-04-07 16:36 ]

Andy Brinkley · Post by **Andy Brinkley** » Sun Apr 07, 2002 5:18 pm

Model C44CLB-7105AT is a UHF (403-475 mhz) 40 watt Analog MSF-5000 repeater(about 30-32 out of duplexer) with DC tone remote board, 120 VAC power supply. Programmable via R-1801. Option codes will cover any "extras"

Will · Post by **Will** » Sun Apr 07, 2002 5:26 pm

Two errors, it IS DC remote control not "dc tone", and is either 403 to 435 or 435 to 475 mhz, determined by the part numbers on the seperate componets.

Andy Brinkley · Post by **Andy Brinkley** » Sun Apr 07, 2002 6:27 pm

Will -
You are correct, I was responding from memory. (it gets worse as I get older!!)

I should have written 435-470 mhz (475 mhz was optional) with DC remote board, 120 VAC power supply. Programmable via R-1801. I don't see any sub-band specific parts other than the "T" that connected the Post Filter & the receiver to the antenna connector.

Andy