Can't for the life of me figure out how to program the PL. There is one currently programmed, but don't know how to change it. I am guessing it is in the HEX editing screen but from there, NO idea where to go... Maybe I am wrong about that and there is another way?? Can someone help???
Thankyou
-motradiodude
Radius R100 ??PL programming??
Moderator: Queue Moderator
-
motradiodude
- Posts: 17
- Joined: Mon Dec 31, 2001 4:00 pm
Hi:
Be advised the R100 Tone Control is either
PL or DPL and can not easily be changed !
If you need both PL / DPL its advised you aquire a External Tone Panel.
Here is some basic information, and if you
need the Original Programming Manual, I do
have a few.
http://www2.4dcomm.com/metrotech/r100_tx.jpg
This will give you some basic info
Monty
<font size=-1>[ This Message was edited by: [email protected] on 2002-04-07 16:38 ]</font>
Be advised the R100 Tone Control is either
PL or DPL and can not easily be changed !
If you need both PL / DPL its advised you aquire a External Tone Panel.
Here is some basic information, and if you
need the Original Programming Manual, I do
have a few.
http://www2.4dcomm.com/metrotech/r100_tx.jpg
This will give you some basic info
Monty
<font size=-1>[ This Message was edited by: [email protected] on 2002-04-07 16:38 ]</font>