Page 1 of 1
Posted: Mon Oct 15, 2001 11:24 pm
by tdilab
Hello,
Got an Astro UHF at Dayton this year.
When powered up, I get the "SELF CHK"
message, 2 seconds later, I get the
error "FL 1/82". After 10 seconds, then
the radio cycle through error FL 01/90.
And, I cannot talk to the Radio using
the RSS & RIB. Anyone can help me please ?
Daniel.
Posted: Mon Oct 15, 2001 11:40 pm
by Pj
Other than the board being bad, open up the radio and check the pin connections. I installed a dvp board in mine, and I bent a pin (didn't realize it) and got the same thing. A connector may not be attached, causing the problem.
Posted: Wed Oct 17, 2001 12:25 am
by tdilab
hello PJ,
Unfortunately, I cannot swap the Astro
Control board because I only have that one.
I did however replaced the whole Control
board by a strandard Spectra and I works !
Do you know exactly what means the FL 31/82
error code or where I could get the list
of all the Spectra Astro error codes ?
Daniel.
On 2001-10-16 03:40, Pj wrote:
Other than the board being bad, open up the radio and check the pin connections. I installed a dvp board in mine, and I bent a pin (didn't realize it) and got the same thing. A connector may not be attached, causing the problem.
Posted: Wed Oct 17, 2001 4:22 pm
by junkyardnut
Your codeplug is toast. If you need assistance with recovery, email me at
[email protected], or you can pay Moto $330 flat rate and they will recover it for you.