Saber Clear

JohnDo · Post by **JohnDo** » Fri Jul 26, 2002 5:22 am

Hi

I have programmed my saber clear as a saber secure ( to get the beep b4 tx ). The radio will rx and scan no probs but will not tx, it beeps as if the switch was in the wrong pos like on a secure saber with no encription modual installed.

No graet problem if it cant be solved, I will just make the correct choice for the radio type and setup all 120 ch again ( lots of fun ).

regards
John

N9LLO · Post by **N9LLO** » Fri Jul 26, 2002 6:34 am

Is this a secure capable radio with the bypass module installed?
If so see if the secure switch is there under there and change it's position with a small screwdriver.

Chris

williamh · Post by **williamh** » Fri Jul 26, 2002 8:51 pm

if it is a clear saber you should "bind" all of the channels to operate in the clear mode.

it should be H400 clear voice slaved to a mode

and program all of the channels to transmit in the clear .... you should get the tone and all will be good in the world

JohnDo · Post by **JohnDo** » Sat Jul 27, 2002 7:11 am

Thanks William , N9LLO

Your on the ball William, Only difference is I had to enable option H401 for
clear voice slaved to a mode ( things must be different here in Australia ).

Thank you for help guys

Many Regards

John
Australia

williamh · Post by **williamh** » Sat Jul 27, 2002 5:44 pm

thats cuz you guy use the upside down version .

glad i could help..

william