Page 1 of 1

MCS 2000 Pinout for dig remote

Posted: Fri Aug 08, 2008 5:25 am
by alannerd614
Hello again,

I am looking for a pinout for an MCS2K to an L3208A Digital Junction box, which will be remoted to an MC3K.

Thanks in advance.

Re: MCS 2000 Pinout for dig remote

Posted: Wed Aug 13, 2008 6:43 am
by alannerd614
Quoi?

Re: MCS 2000 Pinout for dig remote

Posted: Mon Aug 18, 2008 4:24 pm
by motor59
I'll check the manual tomorrow -see if it has a schematic for ya.

Re: MCS 2000 Pinout for dig remote

Posted: Sat Aug 23, 2008 5:42 pm
by motor59
The manual doesn't show the pinouts for the cable, but it does contain the following:

HKN6123 is the MCS2000-Digital Junction Box cable

Pin assignments for the MCS2000 radio port are as follows:
Pin 2 Ground
Pin 4 Ground
Pin 5 Busy Radio
Pin 6 Data+ Radio
Pin 9 Radio Connect
Pin 10 Ground
Pin 11 Receive Input A
Pin 13 Radio Transmit Out
Pin 18 Data- Radio

All other pins are not used.

Maybe this info, plus what's on the Batlabs page for the MCS2000 will get you started.

I'll try to ohm out a cable on Monday for you.