spectra zone setup
Moderator: Queue Moderator
spectra zone setup
Hi guys i dont know how to set up zones on my A9. and can i do that to a A7 dash mount 50 watter too thanks
-
kc7gr
- Posts: 1031
- Joined: Wed Mar 13, 2002 4:00 pm
- What radios do you own?: Motorola, Icom, Sunair (HF).
Re: spectra zone setup
First and foremost, your Spectra's firmware needs to be of a high enough version to support zoned operation. If it is not, you're looking at $225 for a replacement memory module.fidel wrote:Hi guys i dont know how to set up zones on my A9. and can i do that to a A7 dash mount 50 watter too thanks
I seem to recall that versions 5.70 and above support zones. The version number should be on a label on the solder side of the MLM. You will need to open the radio to check this.
Happy tweaking.
Bruce Lane, KC7GR
"Raf tras spintern. Raf tras spoit."
Anything higher that MLM v6.x will properly setup zones.
For best results, you will most likely need to delete all your modes and then go into the zone programming and set them up. When I last did it, thats what I had to do. Made life easier.
For best results, you will most likely need to delete all your modes and then go into the zone programming and set them up. When I last did it, thats what I had to do. Made life easier.
Lowband radio. The original and non-complicated wide area interoperable communications system
