Specta HHCH Scan question

[BikerScout]

I have a Spectra A3 that when I put it in scan the display flashes OL and does not scan.
Scan OFF HUB is enabled.
Also, HUB Switch is Disabled.
Radio is a D43KMA7JA3BK and CH is a HCN1053A.

Bryan

[Jim202]

Don't have my manual available to look at. Let me ask a question here, did you set up a scan list in the RSS and load it back to the radio?

I forget what the OL means right now.

Is this one of the government dual radio setups with the serial interface unit (SIU) between the radio and the control head?

Jim

I have a Spectra A3 that when I put it in scan the display flashes OL and does not scan.
Scan OFF HUB is enabled.
Also, HUB Switch is Disabled.
Radio is a D43KMA7JA3BK and CH is a HCN1053A.

Bryan

[BikerScout]

The radio was read via RSS and modes added. A scan list was set-up and loaded into the radio via RSS. The programming was done by Radio Shop. Didn't notice the OL or DL until I got home.
No SIU unit is being used with this radio. Just the Radio box and a HHCH plugged into the front DB25 connector.

Bryan

[Radiobuff]

Can anybody answer the above or below ?(depending where this gets posted) as I too have a OL flashing on my hhch head and the only thing I did was change 1 mode?
Thanks

[txshooter]

I had one that was tempermental. Check the programming to make sure that it is not programmed to have a siren unit connected. This was the original problem with mine.

Good luck