MTX Scan

arlojanis · Post by **arlojanis** » Wed May 09, 2007 5:19 am

I have a MTX8000 that was trunked and conventional. I did not try the scan before reprogramming. I deleted all but one trunk system and added several conventional channels. The radio shows to be scanning, but does not stop on busy channels. I set up the scan list and all looks good. What did I miss?

Rayjk110 · Post by **Rayjk110** » Wed May 09, 2007 5:47 am

It could be just scanning the trunked system (if it is even an active one in your area).

Max-trac · Post by **Max-trac** » Wed May 09, 2007 11:40 am

In the frequency programming screen, did you select it to use the same scan list that you created? (and check each channel).

arlojanis · Post by **arlojanis** » Wed May 09, 2007 11:52 am

Yes, I did that.