I have an R1225 Repeater but don't have the Dashboard for it. What Pins do i jump on the front of the radio where the dashboard Ribbon Cable Connects to make the radio Power up?? I read that you can operate the repeater without the dashboard if you jump the turnon pins together.
Mike
R1225 Front Panel Pins
Moderator: Queue Moderator
Re: R1225 Front Panel Pins
J8 a 15 pin male connector is on the front with pin 1 under the receiver RF jack.
On J8, pin 8 is battery/13 volts. Pin 7 is switched A+/battery/13 volts. Jumper these two pins with a Berg jumper, like used on computer motherboards.
On J8, pin 8 is battery/13 volts. Pin 7 is switched A+/battery/13 volts. Jumper these two pins with a Berg jumper, like used on computer motherboards.
-
Mikey
- Posts: 410
- Joined: Wed Sep 05, 2001 4:00 pm
- What radios do you own?: CDM1550 LS+, HT1250, MCS2000
Re: R1225 Front Panel Pins
Do i have to jumper any of the pins to enable "Repeat" or just the power pins?
Re: R1225 Front Panel Pins
Just the power pins.