bi directional repeater using cdm1550's

[ems46pa]

hello, having a few problems getting this set up and can not locate my rick manual
uhf recieve radio recieves and lights up cor but no transmit on vhf
vhf recieves but does not light up COR

in the CPS I used the rick tx and Rx settings for the assec. pins

equipment:
cdm1550 vhf
CDM1550 UHF
rick (S2) 1,2,6,8,10,11 are all on 3,4,5,7,9,12 are all off

does everything look right? what is missing

each radio tx and rx fine when working independantly

I need help quick on this as our EMS team is leaving Tue morning for a drill

Thanks
John T

[The Pager Geek]

RICK DIPS are correct.

Redo Mobile Programming:
Radio Configuration Menu>Accessory Pins Tab

Default Rick Settings ARE WRONG. Change to DEFAULT and program as follows:

Accessory Pins for Receiver Radio:
Pin 3 = External Mic PTT (Input) Ative Level LOW with debounce checked
Pin 14 = PL and CSQ Detect (Output) Active LOW without debounce

Accessory Pins for Transmitter:
Pin 3 = External Mic PTT (Input) Ative Level LOW with debounce checked
Pin 8 = PL and CSQ Detect (Output) Active LOW without debounce

Now Check Accessory Configuration FOR BOTH RADIOS:
Debounce Duration = 100
RX Audio Type = Filtered
Ext PTT Audio Source = Ext Mic Audio

good luck
tpg

[ems46pa]

Thanks for your quick reply,

will make the changes in the morning