HT750/HT1250 - volume pot problem - intermittent volume

[g8tzl2004]

The volume pot on my HT750/GP340 series is intermittent. The radio switches on OK but as I "wobble" the volume pot, the audio level varies from what you would expect to a low level.

Any views on the likely cause such as:

- where pot is soldered to PCB needs reflowing?
- dirty volume track - is there an access point to use switch clearner?

Hopefully I will not need to replace the pot.

Thanks

[GlennD]

We replace the pot on a regular basis. As long as you stay clear of the very tiny surface mount components around the high and low side you are golden.

[g8tzl2004]

It it likely just a dry joint where the pot is soldered to PCB or do I need to replace the pot?

[arlojanis]

I replace a lot of Motorola volume controls. I also see a very few that just need resoldering. Look at it good or just solder and try it again.

[g8tzl2004]

Thanks.

Can you remove the volume pot with a standard soldering iron/solder remover - or do you need special "heat" tools?

[d119]

Thanks.

Can you remove the volume pot with a standard soldering iron/solder remover - or do you need special "heat" tools?

You can do it with standard equipment. Just be cautious as always. It's a through-hole device.

[fineshot1]

In case you need to order a new one the part number = 1880619Z06