Hi all,
My radio is locked and i can't remember the password, because this station has not been used for a very long time )))
Could you show algoritm to unlock, if it possible...
Thanks for all info you would give me!
Dima.
(Sorry for my english)
Stornophone 7000( mx3000) unlock
Moderator: Queue Moderator
Re: Stornophone 7000( mx3000) unlock
RSS for Saber don' t work with my radio((
Re: Stornophone 7000( mx3000) unlock
I try RSS for Saber v R07.00 and RSS for MX1000 v R.02.00... its no go((( At first i get a message from RSS " ..Unrecognazeable core or serial bus error" and for MX1000 RSS i have:
- If connected only RIB: "Radio is not connected";
- if connected RIB and Radio: "RIB is not responding".
- If connected only RIB: "Radio is not connected";
- if connected RIB and Radio: "RIB is not responding".
-
- Posts: 51
- Joined: Fri Jun 02, 2006 7:23 pm
Re: Stornophone 7000( mx3000) unlock
1) Can you get the proper RSS for European SABER/MX?
2) Make sure you are using the recommended SLOW 386/486 IBM PC to program.
3) Check your connections and power to the RIB as well as COM port selection.
4) I found that if certain files in the RSS were archived-write protected, a comm failure resulted.
Failing this:
I don't know if this will work, so YMMV, but you might be able to create an entirely new codeplug under US Market RSS and force feed the radio. Try a minimal single channel codeplug with a US model that resembles yours, then go right to programming without reading. I have done this to change models, and I assume the hardware in your radio is same as US market radio. Please don't flame me if it bricks it.
2) Make sure you are using the recommended SLOW 386/486 IBM PC to program.
3) Check your connections and power to the RIB as well as COM port selection.
4) I found that if certain files in the RSS were archived-write protected, a comm failure resulted.
Failing this:
I don't know if this will work, so YMMV, but you might be able to create an entirely new codeplug under US Market RSS and force feed the radio. Try a minimal single channel codeplug with a US model that resembles yours, then go right to programming without reading. I have done this to change models, and I assume the hardware in your radio is same as US market radio. Please don't flame me if it bricks it.
TV DINNER BY THE POOL, IM SO GLAD I FINISHED SCHOOL. FZ