MTX 900 Programming Cable

AngelFire_91 · Post by **AngelFire_91** » Fri Sep 21, 2001 11:45 pm

Hello,
I'm going to make a RIB to Radio cable for a MTX 900, but I was woundering how to make or where I can get the part that connects to the Radio from the cable. The part the connects on top, where the hand mic and similer things are attached? Any help would be thanked.

Mdjonston · Post by **Mdjonston** » Sat Sep 22, 2001 7:05 am

go for a dust cover for that particular radio and drill to fit wire wrap post through. nice & easy.
mike

Chris · Post by **Chris** » Sat Sep 22, 2001 7:38 am

That solution may work, but eventually something WILL go wrong and you'll find yourself paying $230.00 flat rate for a codeplug restoration. Spend a few bucks and buy the universal connector housing, pcb and pins. You'll spend less than $30.00 and have a stable platform for programming. For the same money, you could probably buy a broken speaker-mic and salvage the connector and cable and have an even better solution.

Chris