XTL5000 audio output

whatnext · Post by **whatnext** » Thu Jan 05, 2006 11:00 am

Hello, I have a fire station that wishes to hook the rx audio from their XTL 5000 to their Bogen in house amplifier.. Has anyone done this ?? if so how.. What did u use to couple the output to the amp??.. can they still use the local speaker ??

bnn121 · Post by **bnn121** » Thu Jan 05, 2006 5:38 pm

I looked for my XTL5000 Service manual...but can’t seem to locate it just yet. But, on the back of the radio there is an accessory connector, large square looking thing that should have the leads for the ignition sense and the external speaker. From the accessory connector, there should be a pin/s that provide receive audio independent of the volume attenuation. You will need this pin/s to direct the receive audio into your audio amp. If you tap into the external speaker the volume attenuation of the radio will directly affect the audio level going into the audio amplifier.

If, I find my manual...or find out from somebody at work which pin/s to use I'll post it. Or maybe somebody on this board has the answer.

whatnext · Post by **whatnext** » Fri Jan 06, 2006 4:09 am

Thanks, I have the pin out of the Accy Connector..

radioinstl · Post by **radioinstl** » Sat Jan 07, 2006 7:06 pm

you need to use pin 21 on the rear accy connector this is recieve filtered audio - flat audio that is not affected by the volume control, if you need more info pm me

whatnext · Post by **whatnext** » Tue Jan 10, 2006 4:35 am

Does anyone have 2 or 3 extra pins for the accy plug?? They are needed to hook up cable to amp..

Dave

XTL5000 audio output

XTL5000 audio output

xtl5000