HT 600 Com fail

[BrienD]

I know I have read about this problem before, I can’t find it in the archives.
I have a HT600 H34SVU7160CN
I am trying to read the radio with the HT600 RSS R02.03.01.
The Computer is a 333 MHz P1. Running only Dos.

I can’t get it to read, it will not pass the com test.
The rib and computer well work on Sabers HT1000, Maxtrac radios.
The RIB is an aftermarket version.
I have noticed that the gneiss radios do use different pins on the RIB cable, I opened my RIB and both data bus pins have a trace between them.
So think the aftermarket rib is my week link but I have deserved a doup slap befour.
Thank you,
Brien

[Will]

Computer WAAAY to fast for that software.

The timing for the serial communications is wrong.

[k2hz]

R03.01.00 will probably work on that computer but R02 does not like anything faster than a 486/33.

[BrienD]

I well move my HD to a slower box and try it.
Thank you

[kf4sqb]

Also, as is true with all Genesis series radios, make sure the contacts in the accessory connector on top of the radio are clean. Use a pencil eraser, or an emery board in extreme cases, to clean them.