MSF5000 Fan Panel

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
KENL
Posts: 15
Joined: Tue May 21, 2002 4:08 pm

MSF5000 Fan Panel

Post by KENL »

Just purchased a MSF5000 for ham radio use. It came with a 3 fan panel. Only the middle fan works, can some body tell me if all three should run, I thought maybe the other two are thermostatically controlled. Also how the heck do your open the fan panel to replace a fan.
Top
User avatar
kcbooboo
Batboard $upporter
Posts: 2117
Joined: Wed May 01, 2002 9:03 am

Re: MSF5000 Fan Panel

Post by kcbooboo »

Yes, all three should/could run. However it's usually an overkill. Many people disconnect one or two and keep them around for spares when the remaining one dies.

The fan trays came in 12VDC and 120/240VAC varieties.

Either there are screws (probably Torx), or the case halves just snap or slide together.

Bob M.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”