I just switched vocoders on my xts3000's 800 host 7.5 dspn 7.3.19
To nick radio witch had host 5.51 dsp 6.4, Now I thought the host and dsp would transfer to the other radio, the dsp switched but the host info did not any suggestions
vocoder switch question....
Moderator: Queue Moderator
It was my understanding the HOST firmware was on the controller board, not the vocon. Switch the controller board as well, force in a good codeplug with some form of LAB software & it should be done.
Todd
Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.
Welcome to the /\/\achine.
Welcome to the /\/\achine.
vocoder
Thanks, I figured i hd to switch the controller after i posted the message, all done works great. I just hope there are no problems with the host/dsp..... host 7.05.00 dspn 7.03.19. now only if i can get rid of the nick flash... is the next step.