AS3 (nick special) MDC ID decode issue

This forum is dedicated to discussions pertaining specifically to the Motorola ASTRO line of radios (those that use VSELP/IMBE/AMBE), including using digital modulation, digital programming, FlashPort upgrades, etc. If you have general questions please use the General or Programming forums.

Moderator: Queue Moderator

Post Reply
clavo
Worse than Cowthief
Posts: 515
Joined: Mon Oct 15, 2001 4:00 pm

AS3 (nick special) MDC ID decode issue

Post by clavo »

I searched for this and didn't find any answers.

I have a AS3 with the most recent 'nick flash' and I believe I programmed it wrong.

It will not decode MDC IDs unless the monitor button is held down when the burst is sent. Then it decodes fine. Let go of the monitor button and it doesn't decode.

I'm sure this is a simple fix. Any help here?

-c
Top
Chrisjz
Posts: 82
Joined: Thu Nov 27, 2003 7:15 am
What radios do you own?: Motorola, GE

Post by Chrisjz »

Do you have Data Operated Squelch (DOS) enabled? I have seen this cause the radio not to display MDC ID's. The DOS tab can be found under the individual MDC system or systems you have defined in CPS.
Top
User avatar
Pj
Moderator
Posts: 5147
Joined: Sun Sep 09, 2001 4:00 pm
What radios do you own?: X9000 thru APX

Post by Pj »

Also try knocking the RX unmute delay down to 0.
Lowband radio. The original and non-complicated wide area interoperable communications system
Image
Top
Post Reply

Return to “Legacy Batboard Motorola ASTRO (VSELP/IMBE/AMBE) Equipment Forum”