Quantars,,,,
Say I have an 25W R1 VHF unit....can I place an R1 exciter and 125W R1 PA in it and automatically have a high-powered VHF Quantar?
How bout if I have 100W UHF unit, and replace the PA, receiver and exciter with all VHF equivalents....does it then become a 100W VHF unit?
Does the SAM or EPIC boards have range specific programming to prevent band changes and/or PA changes?
Any help is appreciated!
Quantar Mix-and-Match
Moderator: Queue Moderator
Re: Quantar Mix-and-Match
Yes.
Yes.
No. SAM does not care.
No. The EPIC board can be loaded with any station codeplug regardless of station configuration or frequency with the exception that you can use an IR EPIC for conventional or 6809 trunked but not the other way around.
One issue with mix-n-match Quantar configuration is versions. Ideally, the exciter, station control, and wireline firmware versions should all be of the same release. There is a complete list of the versions included with the programming software.
Yes.
No. SAM does not care.
No. The EPIC board can be loaded with any station codeplug regardless of station configuration or frequency with the exception that you can use an IR EPIC for conventional or 6809 trunked but not the other way around.
One issue with mix-n-match Quantar configuration is versions. Ideally, the exciter, station control, and wireline firmware versions should all be of the same release. There is a complete list of the versions included with the programming software.
Re: Quantar Mix-and-Match
Thanks xmo!
With the mass amount of surplus hitting the street now...they are finally becoming affordable!
Is there a min version of SCM or Exciter f/w that I need for a simple CAI capable conventional repeater?
With the mass amount of surplus hitting the street now...they are finally becoming affordable!
Is there a min version of SCM or Exciter f/w that I need for a simple CAI capable conventional repeater?
Re: Quantar Mix-and-Match
Watch out for the power supplies. Most low transmit power stations also have a low wattage power supply. Thankfully, nothing destructive happens. You just can't transmit. You'll get a PA fail almost immediately.
- The Pager Geek
- Posts: 1250
- Joined: Fri Jun 21, 2002 10:31 pm
- What radios do you own?: Disney FRS
Re: Quantar Mix-and-Match
For p25 you need SCM 20.09.xxx at a minimum. Same goes for Exciter.hoser wrote:Is there a min version of SCM or Exciter f/w that I need for a simple CAI capable conventional repeater?
tpg
Experienced Provider of Useless Information