can some one correct me if im wrong
im setting up a repeater heres what i have
Fb2 freq 463.xxxx that should be out right ? and input 469.xxxx from mobiles
mob1 463.xxxxx should be rx
mob2 469.xxxx should be out
i am in a quietzone but have been authorized by observatory
an licensed by Fcc
thanks for your help sorry if post duplicated could find my first post
i figured how to do it as i actually was writting post but please if one can confirm this is right setup thanks
Setting up new FB2 Repeater
Moderator: Queue Moderator
Re: Setting up new FB2 Repeater
Please don't double post. You need to wait for your posts to be moderated before they will be visible.
This is my opinion, not Aeroflex's.
I WILL NOT give you proprietary information. I make too much money to jeopardize my job.
I AM NOT the Service department: You want official info, manuals, service info, parts, calibration, etc., contact Aeroflex directly, please.
I WILL NOT give you proprietary information. I make too much money to jeopardize my job.
I AM NOT the Service department: You want official info, manuals, service info, parts, calibration, etc., contact Aeroflex directly, please.
Re: Setting up new FB2 Repeater
What is the license call sign so we can take a look at the specifics
-
- was grem467
- Posts: 1145
- Joined: Mon Jul 21, 2003 12:46 pm
Re: Setting up new FB2 Repeater
if you have a 463.xxx output you should have a 468.xxx not 469 input.. UHF in that range is +5 MHz