I just picked up a used convertacomm for my UHF Astro Saber 3.
It says Astro on it and the label says it should work with the Astro 3, but the with the battery on it the radio seems to bottom out before the connector on the
convertacomm is lined up with the connector on the convertacomm. I am using ...

It is a 1 Meg. radio. If anyone on the board is able to upgrade this radio, please email me at [email protected]


Thanks
Bill Moulton
WA6PMW

I have a high split UHF Astro Saber 3 that is in great condition, but is only
flashed as an analog radio. Is it possible to have it upgraded to Support APCO 25?
The Info on the radio now is:
Model Number = H04SDH9PW7AN
Codeplug = 000A
Firmware = 3.20.01.00
DSP Software = I05.00.18
System Package ...

I found a Pro7650 for sale.
Is this a non-US version of the 1250 ?
Is there anything good or bad about it
Compared to a 1250 ?

I have a 800 Mhz MT2000 that I blew the fuse on (fat fingers)
Anyone know where I can get a quick replacement without having to go through Motorola for just a fuse ?

Anyone know of a good source for MT2000 boards and parts cheap ?

I just picked up a Mobile charger off ebay for my Mt-2000.
It has a Light maked Pac*RT and a switch that says Rptr and off.
Can anyone tell me what these are for ???
Model number is TDN9816A
Also wondering what the white wire is for ?

When I first turn on my MT2000, I get the beep, then it says “self test”.
This Msg. will not clear and the radio will not work until I push the side, top
Button that is programmed as “zone/sys select. Is this normal ?
I would think the self test Msg. should clear by itself after a short time.

Thanks for the help. I was not running it in pure DOS.
Works great now.

Does Version 6 for the MT2000 have to be run from pure DOS ?

I am trying to read a new (to me) MT2000,A7 with rss version 6.
I keep getting an error that says "Warning:Communication with radio
failed >Protocol entry error. It is a real Motorola RIB that I use on other radios. Any help ?

I just picked up a MT-2000 A7 (High UHF split) I'ts not why I bought it, but I was wondering if there is any way to get it to play in the 440 ham band ?

I picked up a low band VHF P50 that was thrown in in a trade for some 1250's I wanted. Does anyone have any Info. on this radio ?
Is it crystal or programmable?
I was thinking it might be fun to put on 52.525

Can anyone tell me if it is legal to program a Motorola HT-1250
on the VHF marine band as a backup radio ?
I know it will work, but not sure of the Type acceptance

I've seen a couple of post that mentioned an option board for the 1250
that will let it go out of band. Anybody have any Info on these ???