I am programming a MT2000 for someone and they are telling me with utmost certainty that the PL code for two of their channels is "100.3". This, of course, is an invalid value but this person told me this value can be overridden in RSS. I tried different versions of RSS and depot without success ...

Could someone please provide some clarification:

I want to convert a MT2000 UHF to VHF without performing an alignment. I want to use an RF deck from a working VHF HT1000.

Is this as simple as:
1. Recording all the softpot values from the HT1000 before removing the RF deck,
2. Installing the RF ...

I just received an MTS2000 that I bought on Ebay. I programmed NOAA weather and it does not break squelch. Even when I press "Monitor" all I hear is static. I can't even faintly detect anything other than static. Using another radio, I tested rx and tx and everything worked, but only at a very close ...

I just picked up two MTS2000 model# H01UCH6PW1AN radios and both show "FAIL 01/82" on the display.

Anyone out there encountered this problem and able to resolve it?

If anyone can send me a codeplug for this model, I would GREATLY appreciate it! I already checked codeplugsupersite without success ...

Thanks for the reply.

All channels are enabled in the scan list, so I got those bases covered. Any other thoughts?

I'm programming an HT1000 "D" revision radio (using R03.03.00) and have the side buttons programmed as follows:

Sidebutton 1 = Scan On/Off
Sidebutton 2 = Select Button (nuisance delete)
Sidebutton 3 = Monitor

When I push the top button, nothing happens. Shouldn't there be an alert tone of some ...

Can someone tell me if it's possible to convert a model 3 to model 1?

I have a spare MT2000 case with flex and top display and I can get a good deal on a model 3 MTS2000 with a broken display. I don't want to purchase the MTS unless I can get the display fixed for a reasonable price. Since I ...

This is the post I was thinking about:

JEEEEZ, come on guys , you killing me here.
If you take an HT1000 RF deck and install it with a MTX8000, MTX9000, MT2000, or MTS2000 controller board, you will get what ever band the RF deck is provided you hacked the controller properly.
NOTE, if you try ...

I recall reading a thread on here that discussed converting an HT1000 into a MT2000 simply by switching out a controller board from an MTX radio and placing it into the HT1000. I don't have the particular thread at my fingertips, but I do recall it mentioning that the process was rather easy and ...

I have an HT1000 that's giving me some problems. The light on top of the radio will not illuminate GREEN. The light will illuminate RED when it's supposed to, but never green. This is a problem because when I set the mode switch to scan program, the light is supposed to illuminate green to indicate ...